Clean out the area and ensure that it is completely dry then apply the Bond Boss liquid for moisture damage and waterproofing, for cracks and holes, add in plastering sand followed by another coat of Bond Boss over and allow to dry for 24 hours.

Ensure the surface is clean and fully dry. Apply Hydro Boss™ evenly, allow it to cure for 24 hours, and apply a second coat for stronger protection if needed.

Yes, absolutely. Simply clean out any excess debris and add over a layer of Hydro Boss and allow it to dry for 24 hours.

Both Hydro Boss and Bond Boss last's between 5 - 8 years, depending on conditions exposed to.

1L of Bond boss covers approximately 5 square meters, depending on surface porosity.

1L of Hydro Boss covers approximately 2.5-3 square meters per coat. Two coats are recommended for high-exposure areas.

Bond Boss dries to a clear, matte finish.

Hydro Boss dries to a completely clear finish, maintaining the original look of your surface.

Hydro Boss is used to seal tiles, grout, concrete, stone, brick, painted surfaces, metal, and more. It forms a clear waterproof barrier on both porous and non-porous surfaces, ideal for showers, balconies, roofs, walls, and caravans.

Bond Boss is ideal for use on cement, plaster, brick, sand, mortar, and other porous construction materials. It’s used to seal cracks, fix crumbling walls, prevent damp, and reinforce surfaces from within.

It works on flat metal roofs (new and old), sloped and zinc roofs, IBR/corrugated areas, gutter edges, and irregular roof surfaces. If it's a roof, it's covered.

Concrete and cement floors — garages, driveways, patios, workshops, warehouses, laundry rooms, and basements. Both indoor and outdoor use.